Speck Pumps Model 21-80/34 BS Pump SA103-1600M-0BS - 6 Horsepower - 3 Phase
This item is IN STOCK
This item is TEMPORARILY OUT OF STOCK
Expedited Shipping NOT Available Not Available Outside Contiguous US
Speck Pumps Model 21-80/34 Pump SA103-1600M-0BS
The Speck Model 21-80/34 is a high efficiency pool pump for specialty applications. The Model 21-80/34 is ideally suited for commercial vacuum and sand filters,hydrotherapy, swim spas, waterfalls, water slides, and vanishing edge pool applications.
This pump design provides maximum flow at low head and has 250 cubic inch all plastic strainer tank, and is self-priming up to 4 feet.
- Pool pump ideally suited for commercial vacuum and sand filters,hydrotherapy, swim spas, waterfalls, water slides, and vanishing edge pool applications.
- This high volume, low head pump comes complete with our unique mechanical shaft seal that allows the pump, if mistreated, to run dry for up to one hour.
- The pump can be used for pool water with a salt concentration of up to 5000 ppm.
- Pump parts are made of 100% recyclable plastic. Non-corrosive, chemical/UV resistant, and can withstand temperatures of up to 175° F.
- For pool users’ safety, the impeller has a dielectric shaft sleeve that provides absolute separation between the pool water and electric parts.
- Equipped with 4″ female slip adaptor on suction of strainer tank and 4″ male slip adaptors on the discharge.
- Heavy duty “1081” E-plus/extreme-E energy efficient pool motor with large 56 frame is thermally protected(no motor starter required).
PSC switchless design and extra large sealed ball bearings.
- Motor is easy to remove without disturbing the plumbing. Reusable o-rings throughout.
- Every pump is performance tested before leaving the Speck factory.
- Horsepower:6 Horsepower (6.0 THP)
- Voltage:3 Phase 208-230/460
- Frame:56 Frame
- Service Factor:1.00
Speck Pumps SA103-1600M-0BS